Documents, Videos and Download

This reporting template contains a type of graph, which is quite specialised and should only be applied to 3D components and assemblies.The template divides all data into it’s primary direction of measurement: X (Fore/Aft) Y (IN/OUT) Z (High Low) Each direction must be shown on a separate page, or set of pages. And the CAD [...]

This reporting template contains a graph, which shows a trend or “run chart” with limits and highlights out of tolerance events quickly using red crosses in the graph.ATS CM4D provides quality validation, reporting and analysis tools for quality management of manufactured products and parts.   Download Example of Automotive Trend Report as PDF. This graph [...]

This Template is set up to show constructed features such as distance between points or centre of two points.Otherwise it is very similar to Bar Style Master Points. Each graph shows a trend as a series of coloured bars. The proximity to limits is shown by the bar colour: Yellow - 70% of tolerance Pale [...]

This reporting template contains a very simple type of graph, which shows all features on one page. The boxes show the feature name and direction measured plus the mean and the direction the mean is in. e.g. Z shows Hi/Low or Y shows In/Out. If the mean is close to a tolerance limit it will be [...]

This reporting template contains a useful management level graph, which shows the overall quality of all features in a part or assembly using the four most widely used measures of repeatability.The usual target value for any company working towards 6S quality standards is to have Pp/Ppk above 1.66. Typically Pp/Ppk will be used during development phases [...]

This is perhaps one of the most useful CM4D graphs during an investigation or development phase, yet it is one of the most simple.Each feature on a component is individually evaluated and compared to the 6S standard of Ppk > 1.66. The graph shows the mean and plus/minus 3S as a blue bar with the [...]

This reporting template contains graph set, which is similar to other trend analysis graphs. There is a central trend graph with out of tolerance events highlighted in red and some key statistics (Mean, Range, Pp and Ppk are shown). In this graph however XY and Z are replace by TB and H to match the [...]

This reporting template contains another trend graph style set that is used widely in the US auto industry.The central trend graph shows data and some key statistics are shown. (X-Bar, Range, Cp, Cpk, Pp, Ppk, Min, Max, and valid samples) the tolerances and nominal position for the feature are also shown.   Download Example of [...]

This reporting template contains a complete set of the graphs used by Volvo internally in their interactive system.Suppliers to Volvo are expected to send their measurement data directly to Volvo for analysis by CM4D and are encouraged to perform their own quality analysis as part of product improvement. The reports include: overall [...]

This reporting template contains a graph, which shows a trend as a series of coloured bars. The proximity to limits is shown by the bar colour: Yellow - 70% of tolerance Pale red - outside tolerance Dark red - outside double tolerance The graph contains a number of key statistical values including Mean, Standard Deviation, [...]